Lada USA Discussion Board Forum Index Lada USA Discussion Board
International Lada Forum
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
LadaUSA Store

Acceleration issue

Post new topicReply to topic Lada USA Discussion Board Forum Index -> Technical Information - Do you need help with your Lada?
View previous topic :: View next topic
Author Message
Zvejniex



Joined: 06 Aug 2017
Posts: 2

PostPosted: Sun Aug 06, 2017 11:55 am Post subject: Acceleration issue Reply with quote

Hi,

I have lada 21063, when at idle speeds (~800 rpm) there seems to be "choking" issue when pressing the gas heavily. RPMs decrease and car almost stalls and only then the acceleration happens.

This is 100% carburetor issue because I borrowed another carburetor and everything was fine.

Any ideas? I would really like to fix it rather than buying it new because the parts are scarce.
Back to top
View user's profile Send private message
 
lalunette



Joined: 11 Jan 2008
Posts: 2739
Location: Winnipeg, Manitoba, Canada

PostPosted: Tue Aug 08, 2017 7:12 am Post subject: Reply with quote

Au contraire... parts are not scarce... you can get a whole new carb from LadaMoscow.com !!

That is exactly what I will be doing to bring an '87 2104 back to life as the car has not run / been in storage for over 20 years and the original carb is corroded.
_________________
Richard "Lada" Loiselle
'91 2104 - 5 spd - 1.5L - Weber carb

A bad day working on the Lada is better than a good day at work.
Back to top
View user's profile Send private message
Dneprdude



Joined: 25 Mar 2017
Posts: 78
Location: Wilmington NC

PostPosted: Thu Aug 10, 2017 9:23 am Post subject: Reply with quote

May be float set too high or needle not closing. Or gummed up. Check for any vacuum leaks first though by squirting carb cleaner near throttle shafts and any gasket area. Listen to the rpms. If not, could get a rebuild kit and tune carb as per manual or YouTube.
_________________
-Matt

'74 VAZ 2103
'91 LuAZ 969M
Back to top
View user's profile Send private message
Zvejniex



Joined: 06 Aug 2017
Posts: 2

PostPosted: Thu Aug 10, 2017 11:14 am Post subject: Reply with quote

Dneprdude wrote:
May be float set too high or needle not closing. Or gummed up. Check for any vacuum leaks first though by squirting carb cleaner near throttle shafts and any gasket area. Listen to the rpms. If not, could get a rebuild kit and tune carb as per manual or YouTube.


Thanks, but what needle are we talking about?
Back to top
View user's profile Send private message
 
Display posts from previous:
Post new topicReply to topic Lada USA Discussion Board Forum Index -> Technical Information - Do you need help with your Lada? All times are GMT - 6 Hours
Page 1 of 1


Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB 2001, 2005 phpBB Group